1973 R75/5 Rebuild: Installing a New Clutch

I decided to replace the original clutch after inspecting it and measuring the parts. Many were close to, or past, the minimum thickness. You can read about the procedure I used to install the new clutch in this web page:

I ordered the new clutch parts from Tom Cutter at Rubber Chicken Racing Garage who sent me the following:

21 21 1 250 035 Diaphram Spring (Heavy Duty)
21 21 1 251 801 Pressure Plate
21 21 1 236 332 Clutch Plate
21 21 1 231 666 Compression Ring
21 21 1 231 463 Filister Head Cap Screw (6)

Here are a couple of the pictures included in write-up.

Old (top) & New Clutch Parts

Old (top) & New Clutch Parts, Inside to outside, Left-to-Right

.

Supplies and Special Tools to Mount the Clutch

Toothpick Application of Thin Layer of Honda 60 Molypaste to Edge of Fingers of Diaphragm Spring

Toothpick Application of Thin Layer of Honda 60 Molypaste to Edge of Fingers of Diaphragm Spring

Clutch Diaphragm Spring Against Face of Flywheel

Clutch Diaphragm Spring Against Face of Flywheel

New Clutch Bolts and Long Bolts

New Clutch Bolts Inserted and Long Bolts Ready to be Removed.

Transmission Aligned with Engine

Transmission Aligned and Tight to the Engine Clutch Housing

Leave a Reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.