In page 02 BMW R75/5 General Tear Down, I show how to remove the swing arm from the transmission and the rear drive from the swing arm. This page covers removal and replacement of the swing arm bearings and races and the powder coating of the swing arm.
Here’s a link to the page I wrote up.
And a sample of some of the pictures.
Cycle Works Swing Arm Bearing Puller Kit
Removing the Spacer
Puller Positioned to Remove the Dust Seal
Progresso Soup Can “Sock” Over the Universal Joint
Powder Coated Swing Arm
Swing Arm Bearing Parts-Top to Bottom, Inside to Outside, Left is Drive Shaft Side, Right is Shock Side
Shock Side Showing Bearing Race and Grease Cover Installed
Swing Arm Bearing Installed
Dust Seal with Sleeve Installed