1983 BMW R100RS Remove Tank, Seat & Fairing

Due to the blizzard in Denver yesterday, I had time to finish up some documentation on the project so far and post it to my site. The focus has been on the fairing disassembly and a catalog of the fairing mounting hardware and where it goes. I found existing parts fiche aren’t very helpful about what fasteners go where.

Here is a link to two new publications.

52 BMW 1983 R100RS Remove Seat and Seat Cowling
46 BMW 1983 R100RS Remove Fairing, Dash, Volt Meter, Clock, Ignition Switch

I included a couple videos, one of which shows details of how all the fairing panels are connected.

Here is how the bike looks now.

Tank, Seat, Fairing & Brackets Removed

Tank, Seat, Fairing & Brackets Removed

And the stack of bins the parts are going in, which will increase as I get down to the frame.

Bins for Disassembled Bike Parts

Bins for Disassembled Bike Parts

4 thoughts on “1983 BMW R100RS Remove Tank, Seat & Fairing

    • Chris,

      Well, I can offer you a right top side panel to start with. It shouldn’t take too long to accumulate the parts you need 🙂

      Best.
      Brook.

  1. Good stuff. I enjoy your posts. Wish I was as organized and knowledgeable as you. ..and that’s why I try to read your musings. Thank you.!

Leave a Reply to roberto Cancel reply

This site uses Akismet to reduce spam. Learn how your comment data is processed.